Journal of Inorganic Materials

• Research Letter •    

Preparation, Microstructure and Optical Properties of Tm:LuAG Transparent Ceramics

LI Haiming1,2, YE Junhao2, LI Tingsong2, LU Duyou1, LI Jiang2,3   

  1. 1. College of Materials Science and Engineering, Nanjing Tech University, Nanjing 211816, China;
    2. State Key Laboratory of High Performance Ceramics, Shanghai Institute of Ceramics, Chinese Academy of Sciences, Shanghai 201899, China;
    3. Center of Materials Science and Optoelectronics Engineering, University of Chinese Academy of Sciences, Beijing 100049, China
  • Received:2026-04-30 Revised:2026-05-26
  • Contact: LI Jiang, professor. E-mail: lijiang@mail.sic.ac.cn; LU Duyou, professor. E-mail: duyoulu@njtech.edu.cn
  • About author:LI Haiming (1999-), male, Master candidate. E-mail: 1981007047@qq.com
  • Supported by:
    National Natural Science Foundation of China (52502156); International Partner Program of the Chinese Academy of Sciences (030GJHZ2024026FN)

Abstract: In the field of mid-infrared tunable laser research, transparent LuAG ceramic materials have emerged as a key candidate material due to their excellent combined optical, mechanical, and thermodynamic properties, as well as their low phonon energy (650 cm-1) and unique energy level structure. The co-precipitation method for synthesizing nanopowders offers certain advantages, including high chemical homogeneity and high sintering activity. It has been demonstrated that nanopowders with high sintering activity have the capacity to significantly reduce the temperature and time required for ceramic densification. In addition, they have been shown to substantially decrease the grain size of the ceramic. This renders them a common and effective method for preparing garnet-based transparent ceramic powders. In this study, thulium nitrate, lutetium nitrate, and aluminium nitrate were utilized as raw materials, with ammonium bicarbonate (NH4HCO3) as a precipitant. The resultant 4%Tm:LuAG (in atomic, full text) nanoparticles exhibited an average particle size of ~70 nm. Tm:LuAG ceramics were prepared using a combined method of vacuum pre-sintering (1400-1650 ℃×3 h) followed by hot isostatic pressing (HIP, 1550 ℃×3 h, 200 MPa). It is systematically investigated that the vacuum pre-sintering temperature governs the microstructural evolution and optical transmission behavior of ceramics. It’s shown that by adjusting the vacuum pre-sintering temperature to 1500 ℃ and subsequently HIP post-treating, then air annealing, the prepared Tm:LuAG transparent ceramic sample exhibits a high in-line transmittance of 84.0% at 2020 nm, whose average grain size is about 414 nm. The absorption coefficients of 4%Tm:LuAG (in atomic) transparent ceramics at wavelengths of 682 nm and 783 nm are 18.67 cm-1 and 3.98 cm-1, respectively, and the emission cross section at a wavelength of 2020 nm is 1.19×10-21 cm2. The successful preparation of fine-grained Tm:LuAG transparent ceramics with high-optical-quality is of great significance for enhancing the performance of tunable lasers in the mid-infrared wavelength.

Key words: Tm:LuAG, laser ceramics, co-precipitation, microstructure, optical properties

CLC Number: