Journal of Inorganic Materials ›› 2012, Vol. 27 ›› Issue (5): 495-500.DOI: 10.3724/SP.J.1077.2012.00495

• Orginal Article • Previous Articles     Next Articles

Effect of Fe on the Selective Catalytic Reduction of NO by NH3 at Low Temperature over Mn/CeO2-TiO2 Catalyst

WU Da-Wang1,2, ZHANG Qiu-Lin2, LIN Tao2, GONG Mao-Chu2, CHEN Yao-Qiang2   

  1. (1. Chemistry and Chemical Engineering Department, Qiannan Normal University, Duyun 558000, China; 2. The Key Laboratory of Green Chemistry & Technology (Sichuan University), Ministry of Education, Chengdu 610064, China)
  • Received:2011-05-30 Revised:2011-07-27 Published:2012-05-10 Online:2012-03-31
  • About author:WU Da-Wang. E-mail: wudawang123@126.com
  • Supported by:
    Natural Science Foundation of Guizhou Province of China (2005221);National Natural Science Foundation of China (20773090)

Abstract:

The Mn/CeO2-TiO2 catalyst was prepared using manganese oxide as active component, CeO2-TiO2 as support. Effect of the addition of Fe on the performance of NH3-SCR over Mn/CeO2-TiO2 at low temperature was investigated. These catalysts were characterized by BET surface area, H2 temperature programmed reduction (H2-TPR) and X-ray photoelectron spectroscope (XPS). The activity result shows that the SCR performance of Mn/CeO2-TiO2 is obviously enhanced by the introduction of Fe. The Mn-Fe/CeO2-TiO2 catalyst shows high NO conversion within a wide temperature range of 113-250℃. The characterization results show that the introduction of Fe promotes the dispersion of manganese species on the surface of CeO2-TiO2, and the reduction temperature of manganese species shifts to lower temperature. The XPS analysis indicates that the valence of surface Mn on Mn-Fe/CeO2-TiO2 is +4, while the Fe mainly exists as +3 of Fe2O3, and the strong interaction happens between the Fe and the support.

Key words: iron, selective catalytic reduction (SCR), nitrogen oxides, manganese

CLC Number: