多孔莫来石纤维陶瓷负载La 1-x Sr x CoO 3（x ＝0.2~0.8）的NO+CO催化研究

doi:10.3724/SP.J.1077.2007.00483

无机材料学报

多孔莫来石纤维陶瓷负载La _1-x Sr _x CoO₃（x ＝0.2~0.8）的NO+CO催化研究

段碧林, 曾令可, 李秀艳, 刘平安, 税安泽, 刘艳春

华南理工大学材料科学与工程学院, 广州 510640

收稿日期:2006-06-23 修回日期:2006-08-21 出版日期:2007-05-20 网络出版日期:2007-05-20

Catalytic Activity of La _1-x Sr _x CoO ₃ (x＝0.20.8) Supported on Porous Mullite Fiber Ceramics for NO and CO

DUAN Bi-Lin, ZENG Ling-Ke, LI Xiu-Yan, LIU Ping-An, SHUI An-Ze, LIU Yan-Chun

Department of Materials Science and Engineering, South China University of Technology, Guangzhou 510640, China

Received:2006-06-23 Revised:2006-08-21 Published:2007-05-20 Online:2007-05-20

摘要/Abstract

摘要：

采用真空浸渍法制备了多孔莫来石纤维陶瓷负载La_1-xSr_xCoO₃(x=0.2、0.4、0.6、0.8)钙钛矿型催化剂. 利用XRD、SEM、BET等对样品进行了表征. 通过XRD发现, 所制备的La_1-xSr_xCoO₃催化剂除了存在典型的钙钛矿结构外, 图谱中还发现了La(OH)₃峰, 而且随着x值的减小La(OH)₃ 的衍射峰越来越尖锐. 由SEM可以观察到载体具有立体网状结构并且负载在载体上的催化剂颗粒分散性较好. BET表明随着 x 增加, 比表面积相应增加. 利用一氧化氮(NO)和一氧化碳(CO)对所制备的La_1-xSr_xCoO₃系列载体催化剂的催化活性进行了测试比较, 发现当Sr取代量为x=0.2时, La_1-xSr_xCoO₃整体催化活性较好.

关键词: La1-xSrxCoO3钙钛矿催化剂, 莫来石纤维多孔陶瓷, 载体, 催化活性

Abstract:

Perovskite La _1-x Sr_xCoO₃ ( x=0.2,0.4,0.6,0.8) catalysts based on porous mullite fiber ceramic were prepared by a vacuum impregnation method. The samples were characterized by XRD, SEM and BET, respectively. The La(OH)₃ crystal phase was detected besides the perovskite structures in La_1-xSr_xCoO₃catalysts, and the La(OH)₃ peaks become sharp as x decreases. Tridimensional netshape of support and the good dispersing particles of catalysts based on support were detected by SEM. Specific surface area of La _1-xSr_xCoO₃ increases with the degree of substitution x of Sr for La via BET tests. Catalytic activity of La _1-x Sr _xCoO₃ catalysts prepared for CO+NO was tested. The results indicate that La _1-x Sr _x CoO ₃ catalysts have a best catalytic activity, when partial substitution of Sr for La reaches the optimal substitution fraction ( x=0.2).

Key words: La1-xSrxCoO3 perovskite catalyst, porous mullite fiber ceramics, support, catalytic activity

段碧林,曾令可,李秀艳,刘平安,税安泽,刘艳春. 多孔莫来石纤维陶瓷负载La _1-x Sr _x CoO₃（x ＝0.2~0.8）的NO+CO催化研究[J]. 无机材料学报, DOI: 10.3724/SP.J.1077.2007.00483.

DUAN Bi-Lin,ZENG Ling-Ke,LI Xiu-Yan,LIU Ping-An,SHUI An-Ze,LIU Yan-Chun. Catalytic Activity of La _1-x Sr _x CoO ₃ (x＝0.20.8) Supported on Porous Mullite Fiber Ceramics for NO and CO[J]. Journal of Inorganic Materials, DOI: 10.3724/SP.J.1077.2007.00483.

参考文献

[1] Lndqvist K, Liden E. J. Eur. Ceram. Soc, 1997, 17: 359--366.
[2] Luyten J, Cooymans J, Smolders C, et al. J. Eur. Ceram. Soc., 1997, 17: 273--279.
[3] Aksay I, Dabbs D M, Sarikaya M. J. Am. Ceram. Soc., 1991, 74: 2343--2358.
[4] Terpatra R A, Bonekamp B C, Veringa H J. Desalination, 1988, 70: 395--404. [5] Sepulveda P. Am. Ceram. Soc. Bull., 1997, 76 (10): 61--65.
[6] Voorhoere R J H. Science, 1972, 177: 353--356.
[7] Voorhoeve R J H. in J.J.Burton, R.C.Carter (eds.), Perovskite related oxides asoxidation-reduction catalysts in advanced materials in Catalysis, Academic Press, New York: 1977. [8] Sorenson S C, Wronkiewicz J A, Sic L B, et al. Bull. Am. Ceram. Soc., 1974, 53: 446--449.
[9] Gallagher P K, Johnson D W, Remeika Jr J P, et al. Mat. Res. Bull, 1975, 10: 529--538.
[10] Olivan A M O, Pena M A, Tejuca L G, et al. J. Mol. Catal, 1988, 45: 355--363.
[11] Tascon J M D, Tejuca L G, Rochester C H. J. Catal, 1985, 95: 558--566.
[12] Nagasubramanian G, Viswanathan W, Sastri M V C. Ind. J. Chem. A, 1978, 16: 642--644.
[13] Lindstedt A, Stromberg D, Milh M A. Appl. Catal A: Gen, 1994, 116: 109--126.
[14] Nitadori T, Kurihara S, Misono M. J. Catal, 1986, 98: 221--228.
[15] Nakamura T, Misono M, Yoneda Y. Bull. Chem. Soc. Jpn, 1982, 55: 394--399.
[16] Irusta S, Pina M P, Menendez M, et al. J. Catal, 1998, 179: 400--412.
[17] Phelan D, Louca D, Rosenkranz S, et al. Phys. Rev. Lett., 2006, 96: 1--4.
[18] 杨小毛, 罗来涛, 钟华(YANG Xiao-Mao, et al). 无机材料学报(Journal of Inorganic Materials), 2005, 20 (2): 413--418.
[19] Yamazoe N, Teraoka Y, Seiyama T. Chemistry Letters, 1981, 12: 1767--1770.
[20] Nakamura T, Misono M, Uchijima T, et al. Nippon Kagaku Kaishi, 1980, 11: 1679--1684.
[21] Ferri D, Forni L. Appl. Catal. B: Envir, 1998, 38: 119--126.
[22] Teraoka Y, Harada T, Kagawa S. J. Chem. Soc. Faraday. Trans, 1998, 94 (13): 1887--1891.
[23] Ladavos A K, Pomonis P J. Appl. Catal. A: Gen, 1997, 165: 73--85.
[24] Ladavos A K, Pomonis P J. Appl. Catal. B: Envir, 1992, 1: 101--116.

多孔莫来石纤维陶瓷负载La _1-x Sr _x CoO₃（x ＝0.2~0.8）的NO+CO催化研究

Catalytic Activity of La _1-x Sr _x CoO ₃ (x＝0.20.8) Supported on Porous Mullite Fiber Ceramics for NO and CO

PDF (PC)

可视化

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 15

编辑推荐

Metrics

本文评价

[1]	蔡和庆, 韩璐, 杨松松, 薛新玉, 张扣, 孙志成, 刘儒平, 胡堃, 危岩. 小粒径Fe₃O₄-DMSA-PEI磁性纳米颗粒的制备及其基因负载能力研究[J]. 无机材料学报, 2024, 39(5): 517-524.
[2]	庞力斌, 王德平. 介孔硼硅酸盐玻璃微球药物载体的制备及其性能表征[J]. 无机材料学报, 2022, 37(7): 780-786.
[3]	王鹏, 靳遵龙, 陈宁光, 刘勇豪. Mo掺杂α-MnO₂电催化析氧反应的理论研究[J]. 无机材料学报, 2022, 37(5): 541-546.
[4]	曾雨淋, 陈佳杰, 田正芳, 朱敏, 朱钰方. 介孔有机硅为载体的纳米递送系统制备及其体外化疗-光热联合治疗性能研究[J]. 无机材料学报, 2020, 35(12): 1365-1372.
[5]	高龙, 张赵文斌, 常江. 生物玻璃/聚乳酸多孔微球的制备及其作为细胞载体的研究[J]. 无机材料学报, 2020, 35(10): 1163-1168.
[6]	蒋海燕, 夏云生, 李育珍. 多孔棒状FeVO₄的制备及可见光催化性能研究[J]. 无机材料学报, 2018, 33(9): 949-955.
[7]	黄攀, 周亮, 李华征, 李洪健, 杨建华, 王金渠. 超稀溶液体系中高性能MFI型沸石膜的制备及表征[J]. 无机材料学报, 2018, 33(3): 345-351.
[8]	李永生, 陈玲. 可控制备磁性四氧化三铁-金纳米复合颗粒及其催化性能研究[J]. 无机材料学报, 2018, 33(2): 221-228.
[9]	田晓, 段如霞, 赵丽娟, 那仁格日乐. 直接硼氢化物燃料电池(DBFC)阳极催化剂的研究进展[J]. 无机材料学报, 2017, 32(12): 1233-1242.
[10]	马芳, 崔名芳, 朱建华, 李雅丽. 聚烯丙基氯化铵调控下多孔羟基磷灰石微球的合成及作为药物载体的应用研究[J]. 无机材料学报, 2017, 32(11): 1215-1222.
[11]	朱开平, 孙静, 叶松, 周杰, 王会, 王德平. 新型中空羟基磷灰石微球/壳聚糖复合药物载体用于药物控制释放[J]. 无机材料学报, 2016, 31(4): 434-442.
[12]	赵丹丹, 于彦龙, 高东子, 曹亚安. 金红石二氧化钛纳米片的性质及其光催化活性[J]. 无机材料学报, 2016, 31(1): 1-6.
[13]	马葆禄, 张玥. CNTs/TiO₂复合物制备及光催化性能研究[J]. 无机材料学报, 2015, 30(9): 937-942.
[14]	沈岳松, 纵宇浩, 眭国荣, 韩冰, 祝社民. Ti-Al-Si-O_x脱硝催化剂载体的组分优化及性能研究[J]. 无机材料学报, 2015, 30(5): 542-548.
[15]	魏磊, 黄彦. 炭辅助的固态粒子烧结工艺制备多孔TiO₂/不锈钢膜[J]. 无机材料学报, 2015, 30(4): 427-431.