Journal of Inorganic Materials ›› 2016, Vol. 31 ›› Issue (3): 285-290.DOI: 10.15541/jim20150399

• RESEARCH PAPER • Previous Articles     Next Articles

Stress Induced Microstructure Evolution of AlN: Er Film at Different Annealing Temperature

YANG Ming-Ming1,2(), MO Ya-Juan3, WANG Xiao-Dan3, ZENG Xiong-Hui1(), LIU Xue-Hua1, HUANG Jun1, ZHANG Ji-Cai1, WANG Jian-Feng1, XU Ke1()   

  1. 1. Suzhou Institute of Nano-Tech and Nano-Bionics, Chinese Academy of Sciences, Suzhou 215123, China
    2. Shanghai University School of Materials Science and Engineering, Shanghai 200444, China
    3. University of Science and Technology of Suzhou, Suzhou 215009, China
  • Received:2015-08-25 Revised:2015-11-10 Published:2016-03-20 Online:2016-02-24
  • Supported by:
    National Natural Science Foundation of China(61306004, 51002179, 11247023, 51272270, 61274127, 61474133);Natural Science Fund of Jiangsu Province(BK20130263, BK2012630);National Basic Research Program of China (973 Program)) (2012CB619305);CAS Project of Introduction of Outstanding Technical Talent;Collaborative Innovation Center of Suzhou Nano Science and Technology

Abstract:

The microstructure evolution of AlN: Er during thermal treatment was mainly characterized by weak beam diffraction-contrast imaging and high resolution phase-contrast imaging of the transmission electron microscopy (TEM), which was also supported by X-ray diffraction (XRD) and Raman spectroscopy. Three regions could be observed in the TEM for the implanted samples. The region I is about 30 nm in depth below the surface, the region II is about 50 nm in depth under the region I and is the worst damaged area, and the region III is the area below the reigion II. At relatively low annealing temperature, such as 1025℃, the region I disappears. However, this area can be observed again after annealing at 1200℃. Based on the results of XRD, Raman and TEM, the interesting experiment phenomenon are explained on the view of damage recovery and stress releasing. There is a large stress in the region II due to the large radius difference between Er ions and Ga ions. In the annealing process at 1025℃, the region I is affected by the stress from region II, the lattice distortion in region I is produced. Therefore, the region I is observed as region II under TEM observation. In the annealing process at 1200 ℃, the stress in the region I is released from the surface, the lattice distortion is removed and the region I is observed again under TEM.

Key words: AlN: Er, ion implantation, microstructure evolution

CLC Number: