退火温度对TiO2基电阻开关器件性能的影响

doi:10.3724/SP.J.1077.2012.11776

无机材料学报 ›› 2012, Vol. 27 ›› Issue (10): 1063-1067.DOI: 10.3724/SP.J.1077.2012.11776 CSTR: 32189.14.SP.J.1077.2012.11776

退火温度对TiO₂基电阻开关器件性能的影响

李红霞, 季振国, 席俊华

(杭州电子科技大学电子材料与器件工艺实验室, 杭州 310018)

收稿日期:2012-01-30 修回日期:2012-02-03 出版日期:2012-10-20 网络出版日期:2012-09-17
作者简介:李红霞(1978-), 女, 副教授. E-mail: hxli@hdu.edu.cn
基金资助:
国家自然科学基金(61072015); 浙江省自然科学基金重点项目(ZZ4110503)

Effects of Annealing Temperatures on Resistive Switching Characteristics of TiO2 Based ReRAM

LI Hong-Xia, JI Zhen-Guo, XI Jun-Hua

(Laboratory of Electronic Materials and Devices, Hangzhou Dianzi University, Hangzhou 310018, China)

Received:2012-01-30 Revised:2012-02-03 Published:2012-10-20 Online:2012-09-17
About author:LI Hong-Xia. E-mail: hxli@hdu.edu.cn
Supported by:
National Natural Science Foundation of China (61072015); Natural Science Foundation of Zhejiang Provincial (ZZ4110503)

摘要/Abstract

摘要： 采用直流磁控溅射法在n⁺-Si上制备了TiO2薄膜, 采用电子束蒸发镀膜仪在TiO₂薄膜上沉积Au电极, 获得了Au/TiO₂/n⁺-Si结构的器件. 研究了退火温度对薄膜结晶性能及器件电阻开关特性的影响. Au/TiO2/n+-Si结构的器件具有单极性电阻开关特性, 置位(set)电压, 复位(reset)电压、reset电流及功率的大小随退火温度的不同而不同, 并基于灯丝理论对器件的电阻开关效应的工作机理进行了探讨. 研究结果表明, 500℃退火的器件具有良好的非易失性. 器件高低阻态的阻值比大于10³, 其信息保持特性可达10年之久. 在读写次数为100次时, 器件仍具有电阻开关效应.

关键词: TiO₂薄膜, 电阻开关, 退火温度

Abstract: TiO₂ thin films were deposited on heavily doped silicon wafer by DC magnetron sputtering and the Au electrodes were evaporated on TiO₂/n⁺-Si by electric beam evaporation to get Au/TiO₂/n⁺-Si structured resistive random access memory (ReRAM). The effects of annealing temperatures on the crystalline structure of the TiO₂ thin films and the resistive switching characteristics of the fabricated device were investigated. Au/TiO₂/n⁺-Si structured device exhibits reversible and steady unipolar resistive switching behaviors. The values of set voltage, reset voltage, reset current and reset power vary with the annealing temperatures. The resistive switching mechanism is discussed based on the filamentary model. The results reveal that the fabricated device annealed at 500℃ has good nonvolatile property. The average ratio of resistances between high resistance state (HRS) and low resistance state (LRS) is larger than 10³ and the devices could maintain a sufficient margin of memory for more than 10 years. The resistive switching characteristic is remained after 100 switching cycling tests.

Key words: TiO₂ thin film, resistive switching, annealing temperature

中图分类号:

O472
O484

李红霞, 季振国, 席俊华. 退火温度对TiO₂基电阻开关器件性能的影响[J]. 无机材料学报, 2012, 27(10): 1063-1067.

LI Hong-Xia, JI Zhen-Guo, XI Jun-Hua. Effects of Annealing Temperatures on Resistive Switching Characteristics of TiO2 Based ReRAM[J]. Journal of Inorganic Materials, 2012, 27(10): 1063-1067.

参考文献

[1] JI Zhen-Guo. Non-volatile resistive random access memory based on oxide films. Journal of Inorganic Materials, 2009, 24(4): 754.

[2] Lee S Y, Kim K. Prospects of Emerging New Memory Technologies. IEEE International Conference on Integrated Circuit Design and Technology, 2004: 45–51.

[3] Satoh S, Hemink G J, Hatakeyama F, et al. Stress induced leakage current of tunnel oxide derived from flash memory read-disturb characteristics. IEEE Transactions on Electron Devices, 1998, 45(2): 482–486.

[4] Ielmini D, Spinelli A S, Lacaita A L, et al. A statistical model for SILC in flash memories. IEEE Transactions on Electron Devices, 2002, 49(11):1955–1961.

[5] Ielmini D. Reliability issues and modeling of flash and post-flash memory. Microelectronic Engineering, 2009, 86(7/8/9): 1870–1875.

[6] PAN Feng. Resistance Random Access Memory (ReRAM) is Potential to be the Next-generation Universal Memory. Science Times, 2008-12-4.

[7] Rohde C, Choi B J, Jeong D S, et al. Identification of a determining parameter for resistive switching of TiO2 thin films. Appl. Phys. Lett., 2005, 86(26): 262907–1–3.

[8] Jeong D S, Schroeder H, Waser R. Coexistence of bipolar and unipolar resistive switching behaviors in a Pt/TiO2/Pt stack. electrochem. Solid-State Lett., 2007, 10(8): 51–53.

[9] Fujimoto M, Koyama H, Konagai M, et al. TiO2 anatase nanolayer on TiN thin film exhibiting high-speed bipolar resistive switching. Appl. Phys. Lett., 2006, 89(22): 223509–1–3.

[10] Kim K M, Choi B J, Jeong D S, et al. Influence of carrier injection on resistive switching of TiO2 thin films with Pt electrodes. Appl. Phys. Lett., 2006, 89(16):162912–1–3.

[11] Kim K M, Choi B J, Hwang C S, et al. Localized switching mechanism in resistive switchingof atomic-layer-deposited TiO2 thin films. Appl. Phys. Lett., 2007, 90(24): 242906–1–3.

[12] Kim W G, Rhee S W. Effect of the top electrode material on the resistive switching of TiO2 thin film. Microelectronic Engineering, 2010, 87(2): 98–103.

[13] Go S, Jeong K, Lee K, et al. Effects of Si interlayer on resistance switching of Pt/Si/TiO2/Pt structures. J. Vac. Sci. Technol. B, 2009, 27(5): 2175–2181.

[14] Won S, Go S, Lee K, et al. Resistive switching properties of Pt/TiO2/n+-Si ReRAM for nonvolatile memory application. Electron. Mater. Lett., 2009, 5(1): 29–33.

[15] Li Z G, Wu Y X, Miyake S. Metallic sputtering growth of high quality anatase phase TiO2 films by inductively coupled plasma assisted DC reactive magnetron sputtering. Surface & Coatings Technology, 2009, 203(23): 3661–3668.

[16] Kim Wan-Gee, Rhee Shi-Woo. Effect of post annealing on the resistive switching of TiO2 thin ?lm. Microelectronic Engineering, 2009, 86(11): 2153–2156.

[17] Yoshida C, Tsunoda K, Noshiro H, et al. High speed resistive switching in Pt/TiO2 /TiN film for nonvolatile memory application. Appl. Phys. Lett., 2007, 91(22): 223510–1–3.

退火温度对TiO₂基电阻开关器件性能的影响

Effects of Annealing Temperatures on Resistive Switching Characteristics of TiO2 Based ReRAM

RichHTML

PDF (PC)

可视化

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 15

编辑推荐

Metrics

本文评价

[1]	刘松, 张发强, 罗进, 刘志甫. 0.9BaTiO₃-0.1Bi(Mg_1/2Ti_1/2)O₃铁电薄膜制备及储能特性[J]. 无机材料学报, 2024, 39(3): 291-298.
[2]	王艳香, 高培养, 范学运, 李家科, 郭平春, 黄丽群, 孙健. SnO₂退火温度对钙钛矿太阳能电池性能的影响[J]. 无机材料学报, 2021, 36(2): 168-174.
[3]	王红燕, 张浩, 姜宏, 汪国庆, 熊春荣. 高可见光透过、高紫外截止镀膜玻璃的制备[J]. 无机材料学报, 2017, 32(7): 758-764.
[4]	张涛, 徐智谋, 武兴会, 刘斌昺. 室温下制备非晶ZnO薄膜及其电阻开关特性研究[J]. 无机材料学报, 2014, 29(11): 1161-1166.
[5]	蒋大洞, 郑学军, 龚跃球, 朱哲, 彭金峰. 退火温度对Bi_3.15(Eu_0.7Nd_0.15)Ti₃O₁₂铁电薄膜力学性能的影响[J]. 无机材料学报, 2013, 28(2): 131-135.
[6]	季振国, 王君杰, 毛启楠, 席俊华. Bi₂O₃薄膜的制备及其电阻开关特性的研究[J]. 无机材料学报, 2012, 27(3): 323-326.
[7]	丁卉, 张诺, 戎非, 付德刚. 氮氟共掺杂二氧化钛薄膜的制备、表征及杀菌性能[J]. 无机材料学报, 2011, 26(5): 517-522.
[8]	蒋波, 段学臣, 周志超, 程亚娟, 刘国聪, 刘杨林. SiO₂-TiO₂ 自清洁防反光薄膜的制备与表征[J]. 无机材料学报, 2011, 26(4): 375-380.
[9]	王永霞, 冶银平, 李红轩, 吉利, 陈建敏, 周惠娣. 退火温度对 a-C:H 膜结构及摩擦学性能的影响[J]. 无机材料学报, 2011, 26(2): 209-213.
[10]	刘新军,李效民,王群,杨蕊,曹逊,陈立东. Ti/La_0.7Ca_0.3MnO₃/Pt结构器件中“负”电阻开关特性研究[J]. 无机材料学报, 2010, 15(2): 151-156.
[11]	曹逊,李效民,于伟东,张亦文. PLD法制备TiO₂薄膜及电阻转变特性研究[J]. 无机材料学报, 2009, 24(1): 49-52.
[12]	龙华,杨光,陈爱平,李玉华,陆培祥. 纳米TiO₂薄膜的脉冲激光沉积及其光学特性[J]. 无机材料学报, 2008, 23(5): 1070-1074.
[13]	任明放,王华. 退火温度对Pt/SrBi₂Ta₂O₉/Bi₄Ti₃O₁₂/p-Si异质结微观结构与性能的影响[J]. 无机材料学报, 2008, 23(4): 700-704.
[14]	张剑平,孙召梅,施利毅,贾桂玲,谢晓峰,饶薇薇,朱永法. 负载型TiO₂光催化薄膜结构控制及光催化活性[J]. 无机材料学报, 2005, 20(5): 1243-1249.
[15]	侯亚奇,张弓,庄大明,吴敏生. 中频交流反应溅射TiO₂薄膜制备及光催化性能研究[J]. 无机材料学报, 2004, 19(5): 1073-1079.