AEO9/醇/烷/水系反相微乳液陶瓷墨水制备与性能研究

无机材料学报

AEO₉/醇/烷/水系反相微乳液陶瓷墨水制备与性能研究

郭瑞松; 齐海涛; 李金有; 陈玉如; 杨正方; 袁启明

天津大学材料学院天津 300072

收稿日期:2002-04-15 修回日期:2002-05-30 出版日期:2003-05-20 网络出版日期:2003-05-20

Preparation and Properties of AEO₉/Alcohol/Alkane/Water Reverse Microemulsion Ceramic Inks

GUO Rui-Song; QI Hai-Tao; LI Jin-You; CHEN Yu-Ru; YANG Zheng-Fang; YUAN Qi-Ming

School of Materials Science and Engineering; Tianjin University; Tianjin 300072; China

Received:2002-04-15 Revised:2002-05-30 Published:2003-05-20 Online:2003-05-20

摘要/Abstract

摘要： AEO₉/醇/烷/水系反相微乳液具有相当优异的溶水性能,选择该系用于陶瓷墨水制备,就醇的种类和用量对反相微乳液区的影响进行了研究,划定了该区在拟三元相图中的位置,确定了体系最佳溶水量条件.以ZrOCl₂·8H₂O和NH₃·H₂O溶液分别替代优化体系中的水,获得2个反相微乳液,再将它们混合,通过反应制得陶瓷墨水,测定分析了陶瓷墨水理化性能变化规律,针对喷射打印成型硬件要求,对二者性能匹配性进行重点考察。

关键词: 陶瓷墨水, 反相微乳液, 拟三元相图, 理化性能

Abstract: The AEO₉/alcohol/alkane/water system, which has excellent water-dissolving characteristics, was chosen for the preparation of ceramic inks. In this paper,
different kinds and amounts of alcohols were used to investigate the effects on microemulsion region in the quasi-ternary phase diagram of the system. The
microemulsion region was determined and the conditions for the maximum water-dissolving were given. Water for the optimized system of AEO₉/alcohol/alkane/water was
replaced by zirconium oxychloride solution and ammonia solution respectively and two clear reverse microemulsions were obtained. Then the ceramic inks were
readily prepared by reaction after mixing them homogeneously. The properties of the inks, such as viscosity, surface tension, conductivity, stability etc. were
systematically determined and analyzed. The match between ink and printer was discussed based on the demands of ink-jet printer available.

Key words: microemulsion, ceramic ink, quasi-ternary phase diagram, physicochemical property

中图分类号:

TB383

郭瑞松,齐海涛,李金有,陈玉如,杨正方,袁启明. AEO₉/醇/烷/水系反相微乳液陶瓷墨水制备与性能研究[J]. 无机材料学报.

GUO Rui-Song,QI Hai-Tao,LI Jin-You,CHEN Yu-Ru,YANG Zheng-Fang,YUAN Qi-Ming. Preparation and Properties of AEO₉/Alcohol/Alkane/Water Reverse Microemulsion Ceramic Inks[J]. Journal of Inorganic Materials.

参考文献

[1] Anuradha T V, Ranganathan S. Nanostructured Materials, 1999, 12 (5): 1063--1069.
[2] Jafelicci M Jr, Davolos M R, dos Santos F J, et al. J. Non-Crystalline Solids, 1999, 247: 98--102.
[3] Chive A D, Bruno B, Maurice B. Langmuir, 1998, 14 (19): 5355--5365.
[4] Motte L, Billoudet F, Pileni M P. J. Mate. Sci., 1996, 31 (1): 38--42.
[5] Qi L, Ma J, Cheng H, et al. Colloids and Surfaces A: Physicochemical and Engineering Aspects, 1996, 108 (1): 117--126.
[6] 杨传芳, 陈家镛(YANG Chuan-fang, et al). 无机材料学报(Journal of Inorganic Materials), 1997, 12 (5): 749--754.
[7] Rawlinson D A, Sermon P A. J. De Physique, 1997, 7 (1): C1--755--C1--756.
[8] 郭瑞松, 齐海涛, 郭多力, 等(GUO Rui-song, et al). 无机?材料学报(Journal of Inorganic Materials), 2001, 16 (6): 1049--1054.
[9] Guo R, Qi H, Guo D, et al. J. Euro. Ceram. Soc., 2003, 23 (1): 115--122.
[10] 郭瑞松, 丁湘, 梁青菊, 等. 材料研究学报, 2001, 15 (5): 583--586.
[11] 郭瑞松, 齐海涛, 陈贤礼, 等(GUO Rui-song, et al). 硅酸盐学报(Journal of Chinese Ceramic Society), 2002, 30 (4): 521--523.
[12] Matthew M, Song J-H, Evans J R G. J. Am. Ceram. Soc., 1999, 82 (7): 1653--1658.
[13] Robert C D, Sol S. London: Academic Press, 1988. 328.
[14] 王利军, 梁兴国, 刘志华, 等. 电子计算机与外部设备, 1997, 21 (4): 7--10.
[15] Hou M J, Shah D O. Langmuir, 1987, 3 (6): 1086--1096.
[16] Miller C A, Huan R-N, Benton W J, et al. J. Colloid Interface Sci., 1977, 61 (3): 554--568.
[17] 陈宗淇, 戴闽光. 胶体化学. 北京: 高等教育出版社, 1984. 158.
[18] Bansal V K, Shah D O, O’Connell J P. J. Colloid Interface Sci., 1980, 75 (2): 462--475.
[19] Paul S, Bisal S, Moulik S P. J. Phys. Chem., 1992, 96 (2): 896--901.
[20] Mukhopadhyay L, Bhattacharya P K, Moulik S P. Colloids and surfaces, 1990, 50 (12): 295--308.

AEO₉/醇/烷/水系反相微乳液陶瓷墨水制备与性能研究

Preparation and Properties of AEO₉/Alcohol/Alkane/Water Reverse Microemulsion Ceramic Inks

PDF (PC)

可视化

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 10

编辑推荐

Metrics

本文评价

[1]	朱雨桐, 谭佩洁, 林海, 朱向东, 张兴栋. 可注射透明质酸/羟基磷灰石复合材料: 制备、理化性能和细胞相容性[J]. 无机材料学报, 2021, 36(9): 981-990.
[2]	蔡维维, 李蛟, 何静, 王卫伟. 磷酸银纳米结构的调控及其光催化性能研究[J]. 无机材料学报, 2017, 32(3): 263-268.
[3]	姜晓鑫, 屈树新, 林孙忠, 段可, 翁杰. 骨碎补载入对磷酸钙骨水泥性能的影响及体外生物学评价[J]. 无机材料学报, 2011, 26(1): 29-37.
[4]	余长林, 周晚琴, 杨凯, 李立清. 反相微乳液合成单分散的四方形SnO₂纳米晶[J]. 无机材料学报, 2010, 25(12): 1340-1344.
[5]	王卓,李永祥,杨群保. 无机材料喷墨制备新方法的进展[J]. 无机材料学报, 2009, 24(6): 1090-1096.
[6]	刘云泉,陈小华,张科,易斌,王伟,周灵平. 反相微乳液法合成碳纳米管微球[J]. 无机材料学报, 2009, 24(5): 993-997.
[7]	施建章,汪宏,Werner Jillek,姚熹. BZN陶瓷墨水的制备及其性质研究[J]. 无机材料学报, 2008, 23(2): 257-261.
[8]	王晓红,郭耘,郭杨龙,王筠松,卢冠忠. 高温稳定的Al₂O₃基复合氧化物的制备与性能[J]. 无机材料学报, 2005, 20(4): 895-901.
[9]	郭瑞松,齐海涛,李金有,李鸿祥,陈玉如,杨正方. 提高AEO₉/醇/烷/水体系反相微乳液陶瓷墨水浓度的研究[J]. 无机材料学报, 2003, 18(4): 955-959.
[10]	郭瑞松,齐海涛,郭多力,吕晓娟,陈玉如,杨正方. 喷射打印成型用陶瓷墨水制备方法[J]. 无机材料学报, 2001, 16(6): 1049-1054.