研究论文

低氟MOD法制备Zr掺杂YBCO薄膜的研究

  • 叶 帅 ,
  • 索红莉 ,
  • 刘 敏 ,
  • 汤 潇 ,
  • 吴紫平 ,
  • 周美玲
展开
  • (北京工业大学 材料科学与工程学院, 国家教育部功能材料重点实验室, 北京100124)

收稿日期: 2009-04-13

  修回日期: 2009-06-04

  网络出版日期: 2010-04-22

Zr-doped YBCO Film Prepared by Fluorine-reduced MOD Method

  • YE Shuai ,
  • SUO Hong-Li ,
  • LIU Min ,
  • TANG Xiao ,
  • WU Zi-Ping ,
  • ZHOU Mei-Ling
Expand
  • (The Key Laboratory of Advanced Functional Materials, Ministry of Education, Beijing University of Technology, Beijing 100124, China)

Received date: 2009-04-13

  Revised date: 2009-06-04

  Online published: 2010-04-22

摘要

在金属有机盐沉积(MOD)法制备YBCO薄膜的工艺中, 采用无F的α甲基丙烯酸铜取代原来的三氟乙酸铜, 可以降低前驱溶液中大约50%的氟含量. 研究表明, 该方法大大缩短了YBCO前驱薄膜受热分解的时间, 仅为原来的1/7. 通过XRD、SEM分析发现, 该方法可以制备成分单一、具有良好立方织构的YBCO薄膜, 且薄膜表面平整致密, 没有裂纹, 临界温度(Tc)达到了90K左右, 77K、自场下的临街电流密度(Jc)达到了2.84MA/cm2. 通过在制备的YBCO薄膜中引入6mol% 的 Zr元素掺杂, 有效地提高了YBCO薄膜在外加磁场下的超导性能.

本文引用格式

叶 帅 , 索红莉 , 刘 敏 , 汤 潇 , 吴紫平 , 周美玲 . 低氟MOD法制备Zr掺杂YBCO薄膜的研究[J]. 无机材料学报, 2009 , 24(6) : 1205 -1208 . DOI: 10.3724/SP.J.1077.2009.01205

Abstract

Through replacing copper Tri-fluoroacetate by copper α-methacrylic in Metal Organic Deposition (MOD) process, the total amount of fluorine in YBCO precursor solution was reduced by about 50%. As a result, the calcination period for YBCO precurse film was dramatically reduced. The calcination time was reduced to 2h, only one seventh of that in all-Fluorine MOD process. X-ray diffraction and scanning electronic microscope (SEM) measurements show that YBCO films have strong YBCO(00l) peaks and crack-free surface. The critical temperture (Tc) and critical current density (Jc at self-field, 77K) are 90K and 2.84MA/cm2, respectively. Furthermore, the property of YBCO film prepared by the fluorine-reduced MOD method is enhanced greatly by incorporating 6mol% Zr element into the film.

参考文献

[1]古宏伟, 杨 坚, 刘慧舟, 等. 中国稀土学报, 2006, 6, 24(3):257-267.
[2]Araki Takeshi, Hirabayashi Izumi. Supercond. Sci. Technol., 2003, 16(11):R71-R94.
[3]Mclntyre Paul C, Cima Michael J, Smith John A, et al. J.Appl.Phys., 1992, 71(4):1868-1877.
[4]Teruo Izumi, Yoshitaka Tokunaga, Hiroshi Fuji, et al. Physica C, 2004, 412-414:885-889.
[5]Cui X M, Tao B W, Tian Z, et al. Supercond. Sci. Technol., 2006, 19(4):L13-L15.
[6]Angrisani Armenio A, Augieri A, Ciontea L, et al. Supercond. Sci. Technol., 2008, 21: 125015-125021.
[7]Yoshitaka Tokunaga, Tetsuji Honjo, Teruo Izumi, et al. Cryogenics, 2004, 44: 817-822.
[8]Zhao Gaoyang, Chen Yuanqing, Li Lei, et al. IEEE Transactions on Appiled Superconductivity, 2007, 17(1):40-43.
[9]Foltyn S R, Civale L, MacManusDriscoll J L, et al. Nature Materials, 2007, 6:631-642.
[10]MacmanusDriscoll J L, Foltyn S R, Jia Q X, et al. Nature Materials, 2004, 3(7):439-443.
[11]Gutierrez J, Llordes A, Gazquez J, et al. Nature Materials, 2007, 6(5):367-373.
[12]Liu Min, Suo Hongli, Ye Shuai, et al. Supercond. Sci. Technol., 2008, 21: 115012-115016.
[13]刘 敏, 董 杰, 赵 跃, 等(LIU Min, et al). 无机材料学报(Journal of Inorganic Materials), 2005, 20(5): 1257-1262.
[14]Zhou Y X, Ghalsasi S, Rusakova I, et al. Supercond. Sci. Technol., 2007, 20:S147-S154.
[15]叶 帅, 索红莉, 刘 敏, 等. 稀有金属材料与工程, 2008, 10(37):323-326.
文章导航

/