无机材料学报 ›› 2010, Vol. 25 ›› Issue (11): 1139-1144.DOI: 10.3724/SP.J.1077.2010.01139 CSTR: 32189.14.SP.J.1077.2010.01139

• 研究论文 • 上一篇    下一篇

WC/TiO2纳米复合材料的微结构及性能研究

郑遗凡1,2, 陆月萍1,2, 莫卫民1,2, 李国华2, 赵 娜1,2   

  1. (浙江工业大学1. 分析测试中心; 2. 化学工程与材料学院, 杭州 310014)
  • 收稿日期:2010-02-04 修回日期:2010-03-28 出版日期:2010-11-20 网络出版日期:2010-11-01
  • 基金资助:

    浙江省自然科学基金(Y4080209, Y406094); 浙江省科技计划项目(2007F70039)

Microstructure Characterization and Electrocatalytic Properties of WC/TiO2 Nanocomposites

ZHENG Yi-Fan1,2, LU Yue-Ping1,2, MO Wei-Min1,2, LI Guo-Hua2, ZHAO Na1,2   

  1. (1. Research Center of Analysis and Measurement, Zhejiang University of Technology, Hangzhou 310014, China; 2. College of Chemical Engineering and Materials Science, Zhejiang University of Technology, Hangzhou 310014, China)
  • Received:2010-02-04 Revised:2010-03-28 Published:2010-11-20 Online:2010-11-01
  • Supported by:

    Nature Science Foundation of Zhejiang Province(Y4080209, Y406094); Science and Technology Project of Zhejiang Province(2007F70039)

摘要: 以纳米TiO2为载体, 偏钨酸铵为钨源, 经机械球磨后制备成WC/TiO2前驱体, 将前驱体在900℃, 甲烷/氢气气氛下碳化还原, 获得了系列WC/TiO2纳米复合材料. 采用XRD、SEM、HRTEM、STEM-Z衬度像、EDS-Mapping方法对样品的晶相、微观结构、化学成份及空间分布进行了系统表征; 采用三电极体系粉末微电极方法测试了样品在碱性溶液中的电化学催化活性, 结果表明: 随着碳化还原时间的延长, 样品中钨的物相由WO3→WO2→ W→W2C、WC发生变化; 碳化钨晶粒在20 nm以下且分布于载体TiO2表面; 还原碳化6h样品电化学性能最佳, 此时活性相以WC和W2C为主, 晶粒最细且均匀分布于稳定的金红石载体表面.

关键词: 碳化钨, 二氧化钛, 纳米复合材料, 微结构表征 

Abstract: WC/TiO2 precursor was fabricated by ball-milling a mixture of titania and ammonium metatungstate, then WC/TiO2 nanocomposites were obtained after carbonization under CH4/H2 atmosphere at 900℃. The as-prepared samples were characterized by XRD, SEM, HRTEM, STEM and EDX, and their electrocatalytic activities were measured by microelectrode approach with three electrodes in basic solution. The results show that the crystal phase of tungsten species in the samples changes according to the following order: WO3 →WO2→W→W2C or WC in the carbonization process. The tungsten carbide nanoparticles, which are decorated on the surface of titania, generally have a diameter less than 20 nm. The sample carbonized for 6h mainly have two catalytic active phases of very small size, namely WC and W2C, which are uniformly dispersed on the surface of TiO2 particles. The electrocatalytic measurement shows the sample is most active.

Key words: tungsten carbide, titania, nanocomposite, microstructure characterization

中图分类号: