高级检索
无机材料学报

无机材料学报

• 研究论文 • 上一篇    下一篇

LiZn铁氧体的制备和吸波性能研究

江 红, 郭 佳, 赵 璐, 朱 红   

  1. （北京交通大学 理学院, 北京 100044）
  • 收稿日期:2009-03-11 修回日期:2009-06-26 出版日期:2010-01-24 网络出版日期:2010-01-24

Preparation and Microwave Absorption Properties of LiZn Ferrite

JIANG Hong, GUO Jia, ZHAO Lu, ZHU Hong   

  1. (Department of Chemistry, School of Science, Beijing Jiao Tong University, Beijing 100044, China)
  • Received:2009-03-11 Revised:2009-06-26 Published:2010-01-24 Online:2010-01-24

PDF (PC)

3401

被引次数

26 | 9

摘要：

用溶胶凝胶法制备了Li0.35Zn0.3Fe2.35O4粉体, 采用HP8722ES矢量网络分析仪测量了样品在2～18GHz频率范围的复介电常数εr（εr＝ε′-jε″）和复磁导率μr（μr=μ′-jμ″）. 采用传输线理论公式, 对材料的吸波性能进行了模拟. 结果表明, 随着匹配厚度d的增加, 吸波性能增强. 当d=4mm时, 材料的吸波曲线出现双吸收峰; d=5mm时, 材料的吸收峰值位于4.4GHz, 反射率为-19.96dB, -10dB吸收带为2.8～9.0GHz, 带宽为6.2GHz. 吸波材料在低频区有良好的吸波性能.

关键词: LiZn铁氧体, 吸波性能, 低频

Abstract:

Li0.35Zn0.3Fe2.35O4 ferrite powder was prepared by Sol-Gel method. The electromagnetic parameters εr （εr＝ε′-j ε″） and μr （μr=μ′-j μ″） in 2-18GHz band of the products were tested by HP 8722ES vector network analyzer. Microwave absorbing capability is simulated on the basis of transmission line theory. The result shows that the reflection loss decreases with the increase of thickness(d). When the thickness is 4mm, the absorption curve shows two absorption peaks. When the thickness is 5mm, the absorption peak is located at 4.4GHz, the reflection loss is -19.96dB, and the absorption band of less than -10dB is from 2.8GHz to 9.0GHz with the bandwidth of 6.2GHz. icrowave absorbing capability is good in low frequency range.

Key words: LiZn ferrite, microwave absorbing capability, low frequency

中图分类号: