Research Paper

Preparation and Photoelectric Properties of Al-Ti Codoped ZnO Thin Films with [100] Preferred Orientation

  • JIANG Min-Hong ,
  • LIU Xin-Yu
Expand
  • 1. Department of Information Material Science and Engineering, Guilin University of Electronic Technology, Guilin 541004, China; 2. College of Material Science and Engineering, Central South University, Changsha 410083, China

Received date: 2008-01-03

  Revised date: 2008-03-07

  Online published: 2008-11-20

Abstract

Al-Ti codoped ZnO (ZATO) films with (100) preferred orientation were grown on the glass substrates at room temperature by RF magnetron sputtering. The Al-Ti codoped ZnO ceramic targets used for sputtering were prepared by the conventional solid-state sintering process. The growth mechanism, microstructures and surface figures of ZATO films were investigated by X-ray diffraction (XRD) and scanning electronic microscope (SEM), and its optical and electrical properties were respectively measured using a four-point probe technique and UV-756 spectrophotometer at room temperature. After the ZATO films annealed at 500℃ for 3h, the preferred growth orientation of the films changes from (002) to (100) orientation, and the optic band gap reduces from 3.29eV to 2.86eV, and the average transmittance reduces from 90% to 70%, but the room-temperature resistivity reduces from 1.89×10-2Ω·cm to 1.25×10-3 Ω·cm. And at the same time, there is a super-lattice diffraction ray in the XRD patterns of annealed the ZATO films. The photoluminescence (PL) spectra confirm that there exhibit the near-band-edge (NBE) emission peaks at 380nm, and 410nm, 564nm PL peaks of all the films. After the films are annealed at 500℃ for 3h, the strength of these PL peaks drops, but its positions change little. The above experimental mechanisms were discussed.

Cite this article

JIANG Min-Hong , LIU Xin-Yu . Preparation and Photoelectric Properties of Al-Ti Codoped ZnO Thin Films with [100] Preferred Orientation[J]. Journal of Inorganic Materials, 2008 , 23(6) : 1101 -1105 . DOI: 10.3724/SP.J.1077.2008.01101

References

[1] Nakamura S, Fukai M. Jap. Jnl. appl. phys., 1967, 5: 1473.
[2] Black P W, Wales J. Infrared Physics, 1968, 8: 209--222.
[3] Hilton A R. Journal of Electronic Materials, 1973, 2(2): 211--225.
[4] 陈福泉. 红外与激光技术, 1979, 3: 1--5.
[5] 冯长君. 结构化学学报, 2004, 23(5): 556--559.
[6] 徐士友. 化学物理学报, 2003, 16(3): 203--208.
[7] Holter M R. Fundamentals of Infrared Technology, New York: Macmillan, 1962. 128--129.
[8] Davies M. Infra-red Spectroscopy and Molecular Structure, Amsterdam: Elsevier, 1963. 2--3.
[9] Savage J A. Infrared Optical Materials and their Antireflection coatings, UK: Adam Hilger Ltd., 1985. 7--9.
[10] Randic M. J. Am. Chem. Soc., 1975, 97(25): 6609.
[11] Kier L B, Hall H. Molecular Connectivity in Chemistry and Drug Research, New York: Academic Press, 1976. 82.
[12] 冯长君. 分析科学学报, 2002, 18(2): 27--32.
[13] Weast R C, Astle M J, Beyer W H. Handbook of Chemistry and Physics 69th Ed., 63rd edtion. Florida: CRC Press, 1989. 101.
[14] 蒋玉仁, 刘志国, 刘景亚, 等. 物理化学学报, 2003, 19(3): 198--202.
[15] Deutsch T F. J. Phys. Chem. Solids, 1973, 34: 2091--2104.
[16] Francen, Lussier M. Laser Focus, 1976, 12(12): 47--50.
[17] Wolfe W L, Zissis G J. the Infrared Handbook, Office of Naval Research, Dept.
of the Navy, Washington, D.C., 1978. 7--16.
[18] Reiss H. Progress in Solid State Chemistry, 1st edition. London: Prergamon Press, 1964. 77.
Outlines

/