研究论文

LiZn铁氧体的制备和吸波性能研究

  • 江 红 ,
  • 郭 佳 ,
  • 赵 璐 ,
  • 朱 红
展开
  • (北京交通大学 理学院, 北京 100044)

收稿日期: 2009-03-11

  修回日期: 2009-06-26

  网络出版日期: 2010-01-24

Preparation and Microwave Absorption Properties of LiZn Ferrite

  • JIANG Hong ,
  • GUO Jia ,
  • ZHAO Lu ,
  • ZHU Hong
Expand
  • (Department of Chemistry, School of Science, Beijing Jiao Tong University, Beijing 100044, China)

Received date: 2009-03-11

  Revised date: 2009-06-26

  Online published: 2010-01-24

摘要

用溶胶凝胶法制备了Li0.35Zn0.3Fe2.35O4粉体, 采用HP8722ES矢量网络分析仪测量了样品在2~18GHz频率范围的复介电常数εrεrε′-″)和复磁导率μrμr=μ′-″). 采用传输线理论公式, 对材料的吸波性能进行了模拟. 结果表明, 随着匹配厚度d的增加, 吸波性能增强. 当d=4mm时, 材料的吸波曲线出现双吸收峰; d=5mm时, 材料的吸收峰值位于4.4GHz, 反射率为-19.96dB, -10dB吸收带为2.8~9.0GHz, 带宽为6.2GHz. 吸波材料在低频区有良好的吸波性能.

本文引用格式

江 红 , 郭 佳 , 赵 璐 , 朱 红 . LiZn铁氧体的制备和吸波性能研究[J]. 无机材料学报, 2010 , 25(1) : 73 -76 . DOI: 10.3724/SP.J.1077.2010.00073

Abstract

Li0.35Zn0.3Fe2.35O4 ferrite powder was prepared by Sol-Gel method. The electromagnetic parameters εr (εrε-j ε″) and μrμr=μ′-j μ″) in 2-18GHz band of the products were tested by HP 8722ES vector network analyzer. Microwave absorbing capability is simulated on the basis of transmission line theory. The result shows that the reflection loss decreases with the increase of thickness(d). When the thickness is 4mm, the absorption curve shows two absorption peaks. When the thickness is 5mm, the absorption peak is located at 4.4GHz, the reflection loss is -19.96dB, and the absorption band of less than -10dB is from 2.8GHz to 9.0GHz with the bandwidth of 6.2GHz. icrowave absorbing capability is good in low frequency range.

参考文献

[1]王翠平,陈 辉,黄 凯,等.材料科学与工程学报,2006, 24(3): 451-453.
[2]邢丽英. 隐身材料, 北京:化学工业出版社, 2004: 40.
[3]张永进, 赵石林, 许仲梓. 涂料工业, 2008, 38(9): 62-66.
[4]卓长平, 张 雄, 王雪梅, 等. 材料导报, 2005, 19(4):109-112.
[5]刘顺华, 管洪涛, 段玉平, 等. 功能材料, 2006, 2(37):197-199.
[6]Jin HongDu, Chao Sun, Shuo Bai, et al. J.Mater.Res., 2002, 17(5):1232-1236.
[7]廖少斌, 尹光俊.宇航材料工艺, 1992(2):16-20.
[8]张雪峰, 李哲男, 王威娜, 等.粉末冶金工业, 2006, 16(1):11-16.
文章导航

/