高级检索
无机材料学报

无机材料学报

• 研究论文 • 上一篇    下一篇

SiO2涂层制备工艺对三维碳纤维编织体抗氧化性能的影响

高朋召; 王红洁; 金志浩   

  1. 西安交通大学材料强度国家重点实验室 西安 710049
  • 收稿日期:2002-06-21 修回日期:2002-09-16 出版日期:2003-07-20 网络出版日期:2003-07-20

Influence of SiO2 Coating Preparation Process on the Oxidation Resistance of 3-D Carbon Fiber Braids

GAO Peng-Zhao; WANG Hong-Jie; JIN Zhi-Hao   

  1. State Key Laboratory of Mechanical Behavior of Material; Xi an Jiaotong University; Xi an 710049; China
  • Received:2002-06-21 Revised:2002-09-16 Published:2003-07-20 Online:2003-07-20

PDF (PC)

1100

摘要： 采用溶胶-浸渍法,在三维碳纤维编织体的纤维表面涂覆SiO2涂层。实验研究了涂层制备工艺对编织体抗氧化性能的影响。结果表明,纤维经丙酮、硝酸处理后,再采用粘度为0.01～0.012(Pa·s)、分子生长模式为线性的溶胶浸渍,当涂层厚度为0.5μm左右时,浸渍试样抗氧化性能好,完全氧化失重温度为900℃,较之原始编织体提高300℃。涂层过厚或过薄,编织体抗氧化性能下降,这是由于涂层在纤维表面分布不均匀或与纤维表面结合性较差引起的。

关键词: 溶胶-浸渍法, 三维碳纤维编织体, SiO2涂层, 分子生长模式

Abstract: The SiO2 coating on 3-D carbon fiber braids was prepared by the sol-dipping method. And the influence of
coating preparation process on the oxidation resistance of the braids was also studied. The results show that the oxidation resistance of the dipped sample is
improved 300℃ comparing with the raw braids, when the braids are treated by nitric acid. Then it is dipped with the sol, of which the viscosity
is between 0.01～0.012(Pa·s)and the molecule growth model is linear. The thickness of coating is about 0.5μm. The oxidation resistance
of dipped samples decreases when the thickness of coating is either thicker or thinner, because the coating is coated asymmetrically or combined badly with fiber surface.

Key words: sol-dipping method, 3-D carbon fiber braids, SiO2 coating, molecule growth model

中图分类号: