高级检索
无机材料学报

无机材料学报

• 研究论文 • 上一篇    下一篇

Ce-TZP-(Al2O3)陶瓷与Cr12钢的摩擦磨损行为

郑勇; 李包顺; 张玉峰; 黄校先   

  1. 中国科学院上海硅酸盐研究所; 上海 200050
  • 收稿日期:1998-01-14 修回日期:1998-02-25 出版日期:1998-12-20 网络出版日期:1998-12-20

Friction and Wear Behaviours Between Ce-TZP-(Al2O3 ) Ceramics and Cr12 Steel

ZHENG Yong; LI Bao-Shun; ZHANG Yu-Feng; HUANG Xiao-Xian   

  1. Shanghai Institute of Ceramics; Chinese Academy of Sciences Shanghai 200050 China）
  • Received:1998-01-14 Revised:1998-02-25 Published:1998-12-20 Online:1998-12-20

PDF (PC)

830

摘要： 本文研究了Ce－TZP－（Al2O3）陶瓷在不同载荷（100～500N），不同介质环境（空气、水、醋酸、氨水）下与Cr12钢的摩擦磨损特性根据磨损前后摩擦副表面形貌特征与相成份变化，分析了氧化锆陶瓷的磨损机理．100N时，干摩擦摩擦系数与磨损率较高，此时磨损机理以磨粒磨损为主，在液体介质中摩擦系数与磨损率都较低，磨损机理以分层剥落为主；200N以上时，陶瓷摩擦面上发生马氏体相变，磨损机理以脆性断裂为主．摩擦系数随载荷增加而降低，磨损率与载荷呈线性增加关系．

关键词: Ce-TZP-（Al2O3）, 摩擦磨损, 马氏体相变, 磨粒磨损, 分层剥落, 脆性断裂

Abstract: Friction and wear characteristics of Ce-TZP-(Al2O3 ) against Cr12 steel under the loads of 100--500N were studied in different environments (
air, water, acetic acid, ammonia solution). The wear mechanisms of zirconia ceramics were analyzed based on the morphology and phase composition of all
worn surfaces. Under the load of 100N, the high friction coefficient and wear rate were measured and the main wear mechanism was abrasive wear in air; whereas
in liquid, the friction coefficient and wear rate were all low, and delamination became dominant. Under the load of above 200N, Martensitic transformation occurred on the worn surfaces, and brittle fracture processing
was the controlling mechanism. The friction coefficient decreased while the wear rate increased with increasing load.

Key words: Ce-TZP-(Al2O3), friction &, wear, Martensitic transformation, abrasive wear, delamination

中图分类号: